Heian
Canada – foil
storage Paternoster
  
The foil storage
Paternoster is suitable to use for the storage of all 3D-films, it is
used as a high storage at the membrane press or as a space-saving storage
solution for the 3D foils.
With our Paternoster you
can storage on very small area approximately 2, 4m x 1, 2m a lot of film
rolls (up to 32 rolls of a Ø 300 mm). The
required film is thus immediately available at the push of button. Our
Paternoster are available from 2.8 m up to 6, 0
m as standard Paternoster. Also special solutions are offered by us,
please contact us, we will then find the right solution for your storage.
As additional equipment we offer center sleeves, a manual
cutting station or the full automatic cutting device and we have also
ionization solutions available at Heian Canada Inc.
· Storage rods ø
42.4 mm
· Sleeves inside Ø
max. 82 mm,.
· Load chain as a
hollow pin chain with a breaking load of 100 kN,
· Chain pitch is 50
mm hole to hole and this is the raster for the positioning of the
mounting foil bars.
· Control with a key
switch (dead man) for on / off
· Rotational speed of the chain is approx. 5.5 m /
min
· Voltage 400 V, 3N;
50/60 Hz or as USA Version 480V 60Hz
· Mains cable with
CEKON plug 16A fuse protection (by the customer) 10A slow blow
· ground load data
at least 2, 2 kg / cm²
· Side covering over
the entire height of the Paternoster, guards from 2, 2 m above floor to
top edge of the Paternoster.
· Requirement for
the installation of the Paternoster is a viable, flat and solid floor,
· Floating floors
you can’t install a Paternoster. It is forbidden
Please call 416-951-9505 or Email: Dhaire@Heiancanada.com for
details and pricing.
|
